Troubleshooting Flow Charts
- (AL12) alert 12: on too long
- (AL15) alert 15: missing limit (Slidewinder)
- (AL17) alert 17: bad coin battery
- (AL22) alert 22: interlock failure
- (AL24) alert 24: external relay fault
- (ALE1) alert 1: gate forced open
- (ALE2) alert 2: gate drift close
- (ALE4) alert 4: thermal overload
- (ALE5) alert 5: both limit active
- (ALE6) alert 6: limit not released
- (ALE7) alert 7: frequency shift fault
- (ALE8) alert 8: loop shorted
- (ALE9) alert 9: loop open
- (badp) alert: critical low power
- (ER10) error 10: SlowDown Switch
- (ERR1) error 1: Direction error
- (ERR2) error 2: IES Disconnect
- (ERR3) error 3: hy5a comm error
- (ERR4) error 4: Dual gate
- (ERR7) error 7: menu checksum
- (ERR8) error 8: rpm Sensor
- (ERR9) error 9: batt disconnect
- (FAL1) fault 1: motor run time
- (FAL2) fault 2: photo eye
- (FAL3) fault 3: low voltage sag
- (FAL5) fault 5: limit failed
- (GEB) error: !action blocked gate edge
- (SAFE) alert: Safe mode
- alert 15: no target (SlideSmart & Sapark DC)
- alert 15: no target (WedgeSmart dc)