Help Articles
- Can 636 board slow down before it stops like the 936 and 1050?
- Can I convert a StrongArm M30 /M50 NP to a powered version?
- Can you use an 18VAC 220Ma power supply on a 1050 control board?
- Checking if the battery is good
- Close limit keeps moving further and further (Titan with 636 board)
- Close position not constant on SwingSmart or SwingSmart CNX
- Creating a software profile
- Deactivating memory lock FLOX2R receiver (318N)
- Disabling Bluetooth on SmartCNX
- Display screen not working, contrast is dim, letters are too faint to read
- Dual gate operators not timing well together
- Dual gates will not operate together
- Dual gates will not operator together (intermittent or consistent)
- Edge device is not working as expected
- Emerson Commander SK Variable Frequency Drive- Hardware Fault Codes (HF)
- Emerson Commander SK Variable Frequency Drive- Trip Indications
- EMX IRB-MON photo-eye installation to operators with SmartCNX Controllers: Does the photo-eye receiver have a blue or red circuit board?
- EMX IRB-MON photo-eye installation to Smart Touch or SMART DC Controllers within operators manufactured after 2016: Does this photo-eye have a blue or red circuit board?
- EPMB/A BlueBus wiring
- Exit Probe wiring to 1050 control board
- Exit probe wiring to 636 control board
- Exit probe wiring to 936 control board
- Fault 4, Gate no load, Smart DC operators
- Fire department connection is not operating as expected
- Fire Department Open for SmartCNX, SmartDC and SmartTouch boards
- Gate closes by itself
- Gate moves in direction opposite expected 936 control board
- Gate moves too quickly
- Gate moves too slowly
- Gate opens a short distance, then stops and reverses 936 control board