Submit support request

Sign in

Nice | HySecurity Support Center
Troubleshooting
Troubleshooting Flow Charts

Articles in this section

(AL12) alert 12: on too long
(AL15) alert 15: missing limit (Slidewinder)
(AL17) alert 17: bad coin battery
(AL22) alert 22: interlock failure
(AL24) alert 24: external relay fault
(ALE1) alert 1: gate forced open
(ALE2) alert 2: gate drift close
(ALE4) alert 4: thermal overload
(ALE5) alert 5: both limit active
(ALE6) alert 6: limit not released

See more

TroubleShooting basics: electrical power (STC controlled operators)

January 29, 2020 20:54
Updated

Facebook
Twitter
LinkedIn

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Return to top

Related articles

Troubleshooting Error Code Flowcharts for STC controller
TroubleShooting basics: electrical 1 (STC controlled operators)
TroubleShooting basics: electrical control (STC controlled operators)
(badp) alert: critical low power
SlideDriver Programming & Operations Manual (all models)

Nice | HySecurity Support Center Back to Our Main Site